Ashley Duncan

@Thatgirl2525 This is from planet peptides : General Guidelines for Reconstituting Peptides Reconstitution is the process of adding bacteriostatic water (BAC), sterile water, or another diluent to a lyophilized (freeze-dried) peptide powder to make it injectable. GHK-Cu (Copper Peptide) Reconstitution Recommended Diluent: Bacteriostatic Water (BAC) or Sterile Water Common Reconstitution Ratio: 2mg vial + 2mL bacteriostatic water = 1mg per 1mL solution 2mg vial + 4mL bacteriostatic water = 0.5mg per 1mL solution (more diluted) Mixing Process: Use an alcohol swab to clean the vial’s rubber stopper. Slowly inject the bacteriostatic water down the side of the vial to avoid foaming. Gently swirl (do not shake) until the peptide fully dissolves. Store in the fridge (between 36-46°F / 2-8°C) and use within 7-14 days for best potency. NAD+ (Nicotinamide Adenine Dinucleotide) Reconstitution Recommended Diluent: Bacteriostatic Water or Sterile Water Common Reconstitution Ratio: 100mg vial + 1mL bacteriostatic water = 100mg per mL 500mg vial + 5mL bacteriostatic water = 100mg per mL (common for IV or IM injections) Mixing Process: Use an alcohol swab to clean the vial’s rubber stopper. Slowly inject the diluent down the vial’s side, allowing the powder to dissolve gradually. Gently swirl (DO NOT shake aggressively) to avoid damaging the compound. Store in the fridge and use...Read more...